TACHO SENSOR POSITIONING TEST
© STEVE TUCKETT AUDIO SYSTEMS 2015
P1 P2 P3 P4 P5 P6 P7 P8 P9 P10 P11 P12 P13
SYSTEM SETUP
In order to use the Tacho function, the user is required to glue a small neodymium magnet to the underside of the turntable platter. The next task is to position the Tacho sensor on the turntable plinth so that it is aligned with the magnet. This page is intended to assist the user in accurately positioning the sensor. The user will adjust the position of the sensor while rotating the platter backwards and forwards, when the sensor is in the correct position, the green square in the central panel will light up as the magnet passes over the sensor. When the correct position has been decided, and the sensor glued in place, pressing the "Next" button will take the user to Page 5.
PAGE4
TEST
MAGNET OVER SENSOR P4