EDIT U33 DRIVE VARIABLES
© STEVE TUCKETT AUDIO SYSTEMS 2015
P1 P2 P3 P4 P5 P6 P7 P8 P9 P10 P11 P12 P13
SYSTEM SETUP
Note: Where a single phase output module is detected, a static version of the "motor phase" [8N3S] will be loaded to indicate that phase control is disabled.(See Page8_fig1) Pressing and holding either [N6D] or [N8D] on page 7 will load this page. If this page is accessed via N6D, then the page will load with [8SP1U33], If this page is accessed via N8D, then the page will load with [8SP1U45]. This page allows the user to change the various drive parameters, Start Voltage, Run Voltage, Phase Angle and Pitch. Pressing Exit [8N8] will return the user to Page 7.Pressing [8N1] will load Page 9A, pressing [8N2] will load Page 9B, pressing [8N3] will load Page 9C and pressing {8N4] will load Page 10.Pressing [8N5] will load Page 12, pressing [8N6] will load Page 13.
PAGE8
rpm
percent
cents
P8